 | |
| Altingen, 2005-06-16 Selection of Gravers Extended Since a short time ago, vhf customers have been able to choose from a considerably extended selection of gravers. So the specialist for carbide tools satisfies the requests of numerous customers. Up to now, most of the gravers have had a shank diameter of 3 mm. Now all engraving widths starting with a top angle of 36 degrees are available with shank diameters of 3 mm, 4 mm and 6 mm each. On top of that, all gravers are now available with an engraving width of 0.1 mm for extremely fine engravings. The additional shank diameters make unneccessary changes of the collet chuck obsolete. Especially the use of an automatic tool change becomes easier if one can equip it completely with tools with just one shank diameter. The complete list of all vhf gravers is to be found in the online tool shop under www.carbide-tools.com.
|
|
